Best current price£11.97from B&Q
Shopping.co.uk recommended and popular offers
B&Q£11.97Visit shop B&Q - Crema Granite Quartz Matt 67.5Cm X 1M Self-Adhesive Vinyl Wrap For Doors And Worktops
Visit shop2 offers from £11.97 - £12.49
View price history by clicking the chart icon.
The D-C-Fix Self Adhesive Vinyl Wrap in Cream is designed for DIY enthusiasts and renters looking to refresh their kitchen worktops, cupboard doors, and furniture without a permanent renovation. Its key benefit is the user-friendly, repositionable adhesive that allows for a smooth, professional-looking application on various flat surfaces. A notable caveat is that while it is durable and water-resistant, it requires a clean, perfectly smooth substrate to ensure long-term adhesion and prevent air bubbles.
| Colour | Cream |
|---|---|
| Model Part Number | 5056525368328 |
| Brand | d-c-fix |
Yes, it is water-resistant, but ensure it is not in a position where it will be constantly submerged in water.
The adhesive requires a smooth, flat surface for the best results; textures may cause the film to lift or show imperfections.
It can withstand normal room temperatures and mild warmth, but should not be placed directly on hot surfaces like ovens or stoves.
No, once the adhesive has set and the film is removed, the adhesive strength is significantly reduced and will not adhere properly a second time.
When removed correctly using a hairdryer to warm the adhesive, it should leave no damage and minimal residue.
Use a sharp craft knife or a professional vinyl cutter against a metal ruler for the cleanest straight edges.
Gently lift the edge of the film near the bubble and re-smooth it using a squeegee. If a bubble persists, prick it with a tiny pin and press the air out.
Use a hairdryer to gently warm the edge and re-press it firmly against the surface. Ensure the surface was cleaned of all grease prior to application.
The surface may be too porous or dusty. Clean it thoroughly and ensure it is completely dry before re-applying a fresh piece of film.
To prepare your surface, ensure it is completely dry, free of dust, and grease-free. Use a mild detergent solution to clean the area before application. When cutting the film, allow for an extra 2-3cm of material on all sides for easier handling and trimming.
For long-term care, clean the wrapped surfaces with a soft, damp cloth and mild soap. Avoid using abrasive sponges or harsh chemicals like bleach, as these can dull the vinyl finish or compromise the adhesive. To remove the film, simply heat the vinyl with a hairdryer to soften the adhesive, then slowly peel the sheet away at a 45-degree angle. Any remaining adhesive residue can be cleaned away with warm soapy water or a gentle adhesive remover.
