Floor Drain Gully Trap - Tycner

The dual-sided cover plate offers flexibility in design. You can choose to use the sleek stainless steel finish or tile the other side to seamlessly match your existing flooring, providing both functionality and aesthetic integration.

The side outlet is designed to connect to a standard 50mm outside diameter (OD) pipe.

The height of the drain gully trap can be adjusted from a minimum of 20mm to a maximum of 75mm to accommodate different floor depths.

Yes, this type of floor drain gully trap is suitable for wet room shower floors, provided it is installed correctly with appropriate waterproofing and slope towards the drain.

Typically, the height adjustment is managed by the trap's internal mechanism and positioning during installation. Standard plumbing tools and practices are usually sufficient.

The temporary gully cover is provided to protect the drain opening from damage and prevent debris such as mortar, paint, or dust from entering the drainage system during floor construction or renovation work.

Yes, one side of the cover plate is designed to be tiled. You will need to use appropriate tile adhesive and grout for wet areas, following standard tiling procedures.

Check the cover plate and gully trap for any accumulated hair, soap scum, or debris. Remove and clean as necessary. Ensure the side outlet pipe is not obstructed.

Verify that the trap is correctly installed and sealed to the subfloor, and that the surrounding floor slopes adequately towards the drain. Ensure the height adjustment is properly sealed.

Recheck the height adjustment mechanism. Ensure no debris is present between the trap body and the cover plate. Confirm the subfloor is level.

The sealing around the trap body and flange may be compromised. It may be necessary to remove the trap, reapply appropriate sealant or waterproofing membrane, and reinstall.