Landscape Weed Control Fabric Pegs - 19cm - x100

While they are designed for standard and sandy soils, they can work in rocky ground if you avoid hitting solid rocks; if you encounter heavy resistance, remove the peg and try a position a few centimeters away.

These pegs are made from durable plastic intended for reuse, which is more environmentally friendly than single-use alternatives.

No special tools are required, though a rubber mallet is recommended for easier installation in firmer soil.

Calculate your total perimeter in centimeters and divide by 30 to get a baseline number of pegs needed, then add 10% for overlapping fabric sections.

The material is plastic, meaning it will not rust or corrode even when left in damp soil for long periods.

Increase the density of the pegs by spacing them closer together, or drive them into the ground at a slight angle to create a 'hooking' effect.

Use a sharp tool to create a small pilot hole in the fabric first, or use a mallet to tap the peg through the material.

Ensure the peg is driven deep enough so the top of the barb section is flush with the ground line.