Setup, Compatibility & Care Instructions
Setup:
- Ensure the surface to be painted is clean, dry, and free from grease, wax, and rust. If necessary, sand lightly and apply the included Hycote Grey Primer.
- Shake the aerosol can vigorously for at least two minutes after the mixing ball begins to rattle.
- Perform a test spray on an inconspicuous area to check color and adhesion.
- Hold the can upright, approximately 25-30cm from the surface, and apply thin, even coats.
- Allow adequate drying time between coats as per can instructions.
- For the final coat, apply the Clear Lacquer for added protection and gloss.
Compatibility:
This paint is compatible with most OEM finishes, acrylic, and cellulosic paints. It adheres well to primed surfaces. Avoid using on surfaces not recommended by the manufacturer.
Care:
Store cans in a cool, dry place, away from direct sunlight and sources of ignition. After use, invert the can and spray for a few seconds to clear the nozzle. Clean up any spills immediately with a suitable solvent.