d-c-fix Glossy White Sticky Back Plastic Vinyl Wrap Film - 67.5cm x 15m

While it can be applied to smooth, clean interior walls, it is primarily designed for furniture and flat surfaces. Test in an inconspicuous area first, as removal might affect certain wall paints.

Yes, it offers a high-gloss finish, meaning it is quite reflective and will bounce light, similar to a mirror but with a white color.

Gently warm the film with a hairdryer on a low setting. Then, carefully peel it back at a sharp angle. If residue remains, it can typically be removed with an adhesive remover or mild soap and water.

The film is heat resistant up to 70°C (158°F). It should not be placed in direct contact with very hot objects.

It is best applied to clean, smooth, non-porous surfaces. Applying over wallpaper is not recommended as the texture may show through, and adhesion could be compromised. The wallpaper might also be damaged upon removal.

Application tools such as a squeegee and craft knife are not typically included with the vinyl wrap and would need to be purchased separately.

Carefully lift the edge of the film where the bubble is located and use a squeegee to smooth it out as you reapply. For small bubbles, you can try pricking them with a fine needle and then smoothing.

Ensure the surface is thoroughly cleaned, dry, and smooth. Reapply pressure with a squeegee. For stubborn areas, a gentle application of heat from a hairdryer can sometimes improve adhesion.

Gently peel back the affected section and reapply the film, using a squeegee from the center outwards to avoid trapping air. Avoid stretching the film too much.

Use a sharp craft knife or utility blade and a straight edge or ruler for precise cutting. Replace blades frequently as dull blades can tear the material.