d-c-fix Matt Black Sticky Back Plastic Vinyl Wrap Film - 67.5cm x 10m

While it is heat resistant up to 70°C and wipe-clean, it is not specifically designed for high-traffic, wet, or heat-intensive kitchen countertop use where it might be subjected to prolonged moisture or heat. It is best suited for surfaces like cabinet doors or shelves.

This product is designed for indoor use. Outdoor exposure to UV rays and varying weather conditions can degrade the material and affect its adhesion and appearance.

Clean the surface using a soft, damp cloth. For tougher stains, use a mild detergent diluted in water, then wipe clean with a damp cloth and dry thoroughly. Avoid abrasive cleaners.

It is best to apply this vinyl wrap to smooth, clean, and dry surfaces. Applying over textured wallpaper may result in an uneven finish and poor adhesion. Removing the wallpaper first is recommended.

Roll the remaining film with the adhesive side inward to protect it. Store it in its original packaging or a protective tube in a cool, dry place away from direct sunlight.

The adhesive is designed for long-term application on suitable surfaces. Its removability means it can be taken off when desired, but it is intended to maintain its adhesion under normal indoor conditions.

When applied to properly prepared and fully cured paint, this vinyl wrap is designed to be removable without damage. However, on delicate or old paint, there is always a slight risk. Testing in an inconspicuous area is recommended before full application.

Carefully lift the affected section of the film and reapply, smoothing out the bubbles with a squeegee or cloth as you go. For stubborn bubbles, a pinprick can release trapped air, then smooth it down.

Ensure the surface is thoroughly cleaned, dried, and free from dust or grease. Very old paint or certain types of plastic may not provide an ideal surface; test in an inconspicuous area first.

Ensure you are using a sharp craft knife for cutting and apply gentle, steady pressure. Be careful not to stretch the vinyl excessively when applying, especially around curves.

While designed to be removable, residue can occur on older surfaces or if the film has been applied for a very long time. Gentle warming with a hairdryer on a low setting can help soften the adhesive for easier removal. Clean any residue with a mild adhesive remover or soapy water.