Best current price£109.82from City Plumbing GB
Shopping.co.uk recommended and popular offers
City Plumbing GB£109.82Visit shop Drayton 22Mm 2-Port Valve Twin Pack P27100
Visit shop
B&Q£142.78Visit shop B&Q - 22mm 2-Port Valve Twin Pack P27100
Visit shop2 offers from £109.82 - £142.78
View price history by clicking the chart icon.
The Drayton 22mm 2-port valve (P27100) is designed for heating engineers and DIY-capable homeowners who need to manage zone-specific heating or hot water circuits efficiently. It provides a reliable method for redirecting water flow within central heating systems, offering the key benefit of industry-standard compatibility for seamless retrofitting. A notable caveat is that while the actuator is easy to replace, proper plumbing knowledge is required for the initial installation of the valve body to ensure a watertight seal.
| Model Part Number | P27100 |
|---|---|
| Brand | Drayton |
Yes, the snap-on design allows you to remove and replace the actuator head without breaking into the water circuit.
This is a 2-port valve; Y-Plan systems typically require a 3-port mid-position valve, though 2-port valves can be used in specific custom configurations.
There are directional arrows on the valve body casting; the water flow must follow this direction for proper operation.
No, this specific model is designed for 22mm pipework. You would need reducing adapters to fit it to smaller pipe sizes.
Most models feature a manual lever on the side; when the valve is powered open, the lever will move towards the 'manual open' position.
Check if there is 230V power at the orange wire; if power is present but the valve does not move, the actuator motor may have failed.
The valve may be physically stuck in the open position due to debris; check the manual override lever on the actuator or inspect the valve internals.
Verify that the valve body nut is tightened correctly; if the leak persists from the spindle, the valve head may require replacement.
To install the valve, ensure the heating system is fully drained and isolated. The valve body must be installed in the direction of the flow, as indicated by the arrows cast into the valve casing. Once the body is plumbed in and leak-tested, the snap-on actuator can be attached. For compatibility, ensure your controller and wiring center follow standard color-coding (usually Brown, Blue, Grey, Orange, and Earth). Maintenance is minimal, but it is recommended to test the valve operation annually before the start of the heating season to ensure the motor is not stuck. Avoid using excessive force when snapping the actuator on or off.
