IBC S60X6 Cap with 25mm MDPE Elbow - Cost Wise

S60x6 refers to a standard coarse buttress thread commonly found on IBC (Intermediate Bulk Container) tanks. It has a 60mm nominal outside diameter and a 6mm pitch.

MDPE stands for Medium Density Polyethylene. It is a flexible, durable, and corrosion-resistant plastic pipe commonly used for water distribution and irrigation systems.

No, the MDPE compression fitting is designed for tool-free installation, relying on a threaded nut that is tightened by hand. However, a wrench might be helpful for initial tightening or if the nut is stiff.

This specific kit is designed for 25mm MDPE pipes. Using it with different pipe sizes or types is not recommended and may result in leaks or connection failure.

PTFE tape is often recommended for the BSP thread connection to ensure a watertight seal, especially for potable water applications or higher pressures. It is not explicitly included with the kit.

The MDPE fittings included are PN10 rated, meaning they can withstand pressures up to 10 bars (approximately 145 PSI).

While MDPE is generally considered safe for water, it is crucial to ensure that the IBC tank itself and all connected components are suitable for potable water and have been cleaned appropriately. Always check local regulations for potable water systems.

Ensure the S60x6 cap is screwed on tightly. Consider using PTFE tape on the IBC tank threads if they appear worn or damaged.

Apply or reapply PTFE tape to the 1" BSP female thread on the cap before attaching the elbow fitting. Ensure the elbow fitting is securely tightened onto the cap.

Ensure the MDPE pipe is fully inserted into the fitting and that the compression nut is tightened evenly and firmly. Check that the pipe is the correct 25mm diameter and is not damaged or deformed.

Check for any blockages within the IBC tank, the cap, the elbow fitting, or the MDPE pipe. Ensure the IBC tank's valve is fully open.