Danelaw Roll Out Ridge/Hip System - HD CON6+ - 6m

The trimmable gasket allows the installer to precisely adapt the system to the specific contours of the ridge or hip line, ensuring a seamless and weather-tight fit regardless of minor variations in roof pitch or structure.

The system features integrated continuous water channels that direct water away from the ridge or hip, combined with self-sealing details that enhance protection against moisture penetration.

The broader corrugation profile is designed to accommodate a range of roof pitch configurations, offering flexibility for various applications. However, always confirm compatibility with specific project requirements.

The system is supplied in a 6-meter length (HD CON6+).

The system features a wider Butyl strip that provides strong, long-lasting adhesion to the roofing substrate when firmly pressed into place.

Basic roofing tools, including a sharp utility knife for trimming the gasket and a roller for applying pressure to the Butyl strip, are typically required. Standard safety equipment for roofing work should also be used.

Minimal maintenance is required. Regular visual checks for debris or damage are recommended. Keep the channels clear of obstructions like leaves.

Ensure the gasket has been precisely trimmed to fit the contour of the roofline. Verify the roofing substrate is clean and dry before applying the Butyl strip for maximum adhesion.

Check that the continuous water channels are clear of debris. Ensure the system has been installed flat and without any significant dips or high points that could impede drainage.

The substrate must be completely clean, dry, and free from dust or oils. Ensure sufficient pressure was applied during installation to activate the adhesive. Avoid installation in freezing temperatures or on wet surfaces.

Carefully inspect for any tears or cuts in the gasket or material. If damage is found, it may require localized repair or replacement of the affected section, following manufacturer guidelines.