Polypipe Solvent Weld Overflow System Reducer - White - 32mm X 21.5mm - S415W

This reducer is only compatible with solvent weld waste and overflow pipes. It is not compatible with push-fit systems.

Use solvent cement such as SC125 or SC250. Ensure the solvent cement is suitable for use with ABS and uPVC materials.

Apply solvent cement evenly to both the inside of the reducer and the outside of the pipes. Insert the pipe fully into the reducer and hold it in place for a few seconds. Allow sufficient curing time.

Yes, this reducer is designed to perform at higher operating temperatures, making it suitable for hot water applications in residential settings.

The product specifications, including dimensions, can be found on the Polypipe website or in the product packaging.

Clean the reducer with a damp cloth. Avoid using harsh chemicals or abrasive materials.

Ensure the correct solvent cement (SC125 or SC250) was used and applied adequately. Reapply solvent cement to the connections after cleaning the parts. Make sure the pipes are fully inserted and held in place during curing.

Ensure the pipe ends are properly cut and deburred. If necessary, use a pipe cutter to ensure a clean, even cut. Check for any obstructions within the pipe or fitting.

Confirm that the correct solvent cement was used and that it is within its expiry date. Allow sufficient curing time as recommended by the solvent cement manufacturer before testing the connection.