Masonry Drill Bit - 10mm x 160mm
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The AB Tools 10mm x 160mm masonry drill bit is designed for professional contractors and DIY enthusiasts who require a reliable tool for drilling into hard surfaces like concrete, stone, and brick. Built from heat-treated steel with a carbide tip, this bit offers exceptional longevity and cutting efficiency under heavy impact; however, it is strictly intended for SDS-compatible drill machines and will not fit standard three-jaw chuck power drills.
All features
| Model Part Number | BPT297 |
|---|---|
| Brand | AB Tools |
Extended Product Information
FAQs
Can I use this bit in a standard cordless drill?
No, this bit is specifically designed for SDS drill machines and will not fit a standard three-jaw chuck.
Is this bit suitable for drilling through tiles?
While it can drill through brick and stone, it is not recommended for ceramic or porcelain tiles as the hammer action may crack the surface.
What is the total length of this drill bit?
The total length of this specific bit is 160mm.
Does this bit require a special lubricant?
No, masonry drilling is performed dry. Using lubricants can cause dust to clump and clog the flute.
Can this be used for drilling into wood?
No, this bit is designed exclusively for masonry materials. It will not provide a clean hole in wood and may damage the material.
Troubleshooting
Bit is getting stuck in the hole
Ensure you are using the hammer setting on your drill and occasionally pull the bit back while rotating to clear out the masonry dust.
Drill bit is slipping in the chuck
Verify that the SDS shank is fully seated in the drill chuck and locked into position.
Excessive heat build-up during use
Apply less pressure to allow the carbide tip to work and ensure you are removing the bit frequently to evacuate dust.
Pros and Cons
Pros
- High-grade carbide tip for long-lasting sharpness
- Heat-treated steel resists deformation under stress
- Secure SDS fitting prevents slippage in the drill
- Effective debris removal due to specialized geometry
Cons
- Not compatible with standard keyless or keyed drill chucks
- Cannot be used for drilling through metal or wood
- 160mm length may be too long for some tight-clearance drilling tasks
Setup, Compatibility & Care
To install, simply slide the shank into the SDS chuck of your drill until you hear a click. Ensure the drill is set to the appropriate percussion mode. Compatibility is limited to SDS-plus or standard SDS drilling machines; it will not fit drills without an SDS chuck system.
To prolong the life of your bit, avoid overheating. If drilling a deep hole, remove the bit periodically to clear out dust and allow it to cool. Always store the bit in a dry, rust-free environment. After use, inspect the carbide tip for chips or excessive wear; if the tip becomes blunt, it should be replaced to prevent excessive strain on the drill motor.