Mr Hobby Premium Top Coat Gloss Spray - B-601

Allow approximately 5-10 minutes between thin coats in normal conditions. Ensure the previous coat is dry to the touch before applying the next.

Yes, it can be used on bare plastic, but for best results and adhesion, it is recommended to prime the surface first.

Apply in a well-ventilated area with moderate temperature (15-25°C) and low humidity to ensure optimal drying and finish.

Wet overspray can typically be cleaned with a solvent like isopropyl alcohol or lacquer thinner, depending on the surface. Dried overspray may require careful sanding.

Yes, like most aerosol sprays, this product contains propellants and should be kept away from heat, sparks, and open flames.

When stored correctly in a cool, dry place, the spray can typically maintain its efficacy for several years. Always check for any signs of corrosion or leakage before use.

Ensure the can is shaken thoroughly before and during use. Maintain a consistent spray distance (20-30 cm) and use even, sweeping motions. Apply in multiple thin coats rather than one heavy coat.

Immediately after spraying, turn the can upside down and spray for 1-2 seconds to clear residual paint from the nozzle. If clogged, try removing the nozzle and soaking it in lacquer thinner, then rinsing thoroughly.

The spray was likely applied too close or too heavily. Allow the area to dry completely, then gently sand down the runs with fine-grit sandpaper and reapply in thin, even coats.

This can occur if applied in humid conditions or if the surface was not properly prepared. Ensure the surface is clean and dry, and apply in a low-humidity environment. May require additional coats or a different type of clear coat.