John Guest Speedfit 12mm Push Fit 2 Way Y Divider - Black - Pack of 2

To disconnect, push the collet firmly inwards towards the body of the fitting while simultaneously pulling the pipe outwards. A disconnect grip tool can be helpful if the connection is tight.

While John Guest Speedfit fittings are commonly used for both air and water, this specific product description focuses on air piping systems. For critical water applications, always refer to the manufacturer's specific recommendations for intended use.

The product information does not specify a maximum pressure rating. For detailed specifications, consult the official John Guest technical documentation for their Speedfit range.

The fittings are made of tough engineered plastic, which generally offers good resistance to environmental factors. However, prolonged exposure to direct sunlight or extreme temperatures may affect longevity. Assess suitability based on specific environmental conditions.

The fittings are designed for compatibility with John Guest tubing and specified soft metal pipes. While some other 12mm tubing might appear to fit, performance and seal integrity cannot be guaranteed. It is recommended to use compatible tubing for optimal results.

This product is sold as a pack of 2 (two) Y dividers.

Ensure the pipe is cut square and free of burrs. Verify the pipe diameter is 12mm and that it is compatible with John Guest fittings. Check for any debris inside the fitting's entry point.

Disconnect and reconnect the pipe, ensuring it is pushed in fully. Inspect the pipe end for damage or deformation. The pipe may be slightly out of round; try rotating the pipe slightly before reinserting.

Ensure the collet is fully released by pushing it inwards towards the fitting body while pulling the pipe. If difficult, a John Guest disconnect grip tool can assist.

Verify the pipe is fully inserted and the collet is not obstructing the flow path. Check for any kinks or blockages in the connected tubing or downstream equipment.