Best current price£510.89from Rapid Online - Rapid Electronics Ltd.
Shopping.co.uk recommended and popular offers
Rapid Online - Rapid Electronics Ltd.£510.89Visit shop Sauter TD 225-0.1US Ultrasonic Thickness Meter
Visit shop1 offer from £510.89
View price history by clicking the chart icon.
The Sauter TD 225-0.1US is a precision ultrasonic thickness gauge designed for engineers, quality control inspectors, and maintenance professionals who need to accurately measure the thickness of various materials. Its primary advantage is the external sensor, which allows for effortless measurements in tight or difficult-to-reach locations. While it excels in versatility and range, users should note that consistent measurement accuracy depends on proper surface preparation and the use of the correct acoustic coupling agent.
| Model Part Number | TD 225-0.1US |
|---|---|
| Brand | Sauter |
It is used for non-destructive testing to measure the thickness of materials like metal, plastic, or glass.
No, this gauge is specifically designed for solid materials that allow ultrasonic waves to travel through them.
It is recommended to check the calibration using a reference block before starting a series of measurements to ensure accuracy.
Different materials transmit sound waves at different speeds; adjusting this setting ensures the thickness calculation is accurate for the specific material being tested.
Use the unit selection button on the front panel to cycle between inches and millimeters.
Typically, ultrasonic couplant is included with the gauge, but it must be purchased separately if exhausted.
Ensure sufficient coupling gel is used and the probe is held firmly and squarely against the surface.
Check that the material thickness is within the 1.2mm to 225mm range and ensure the sound velocity is set correctly for the material.
Verify the RS232 cable connection and ensure the communication software on your PC matches the baud rate settings of the gauge.
To set up the unit, install the batteries according to the polarity markings in the compartment. Connect the external probe to the device port before powering on.
Compatibility: The device interfaces via RS232; if your workstation lacks a serial port, use an RS232-to-USB converter.
Care Instructions:
