Draper Drill Powered Pump - 18937

The Draper Drill Powered Pump is suitable for transferring various fluids, including water, pond water, and some non-corrosive liquids. Avoid using it with highly viscous fluids, abrasive materials, or solvents that could damage the pump.

The pump is supplied with two 13mm (1/2”) adaptors to fit 13mm (1/2”) diameter pipes.

After each use, flush the pump with clean water. Store in a dry place. Regularly inspect for wear or damage.

Yes, it is designed to work with standard drills. Ensure the drill chuck can securely hold the pump's drive shaft.

Check the drill's power source (battery or electrical connection). Make sure the drill is securely attached to the pump and operating correctly.

The pump can pump up to 1000 litres per hour.

The pump is designed for intermittent use. Avoid running it continuously for extended periods to prevent overheating and wear.

Contact Draper or your local hardware store to inquire about replacement parts.

Ensure the drill is securely attached to the pump and is running at an appropriate speed. Check that the inlet and outlet hoses are not blocked or kinked. Verify that the pump is fully submerged in the fluid if necessary.

Check for any obstructions in the pump or hoses. Clean the turbine if necessary. Ensure the fluid viscosity is within the pump's operational range. Check the drill's battery (if applicable) or power source.

Inspect all connections (hoses and adaptors) for leaks and tighten as needed. Examine the pump body for any cracks or damage. Replace any worn or damaged parts.