Sealey Optical Laser/Lazer Wheel Alignment Tracking Gauge - GA50

The GA50 uses 2 x AA batteries.

It is compatible with cars and light commercials with rim diameters from 200mm to 600mm.

Follow the calibration instructions provided in the operating manual. This typically involves setting the gauge on a flat surface and adjusting the laser beam.

Yes, the single-leg design and reversible probes make it suitable for use on vehicle lifts and ramps.

Use a soft, dry cloth to clean the exterior. Avoid using liquids that could damage the internal components.

The operating instructions are included with the GA50.

Replace the batteries and ensure the laser lens is clean. Check the surrounding environment to ensure the beam is not obstructed.

Warranty information can be found in the product documentation.

Check the batteries and replace if necessary. Ensure the gauge is switched on and that the environment is not too bright, which might affect laser visibility.

Ensure the gauge is properly calibrated according to the instructions. Check for any obstructions or interference affecting the laser beam.

Verify the rim diameter is within the GA50's supported range (200-600mm). Check that the probes are correctly positioned and that there are no obstructions.