Solvent Waste 92.5 Swept Bend - 50mm - White

This fitting is exclusively for solvent weld waste pipe systems. It requires solvent cement for a permanent, watertight bond.

While it's a solvent weld fitting, it's designed for specific solvent weld waste systems. Always confirm compatibility with your specific pipe type and the recommended solvent cement. It is not a universal fitting for all solvent cement applications.

A 92.5-degree swept bend provides a gentler curve than a standard 90-degree elbow, reducing resistance and the likelihood of blockages in waste pipe systems. The 'swept' design indicates the curve is smooth and gradual.

You will need a pipe cutter (or saw) for a clean cut, a deburring tool to smooth the pipe end, solvent weld primer and cement, and a clean cloth. A tape measure is also useful.

Curing times vary depending on the product and environmental conditions (temperature, humidity). Typically, initial set is within minutes, but full cure can take several hours. Always follow the specific instructions on the solvent cement packaging.

This fitting is intended for standard domestic waste systems. It is not rated for high-temperature or pressurized applications. Consult product specifications for temperature limits.

Ensure the pipe was fully inserted and held during the initial set time. Re-cut and re-join, ensuring surfaces are clean and solvent cement is applied correctly and allowed to cure fully.

Check for debris inside the fitting or on the pipe end. Ensure the correct 50mm diameter pipe is being used and that it is cut square. A small amount of primer can sometimes aid insertion, but ensure it is compatible with the cement.

Verify that the pipe is cut to the correct depth and that there are no obstructions. Ensure the bend is not warped or damaged.