PocketWizard Motor Drive Cord - Nikon 10 Pin

The primary benefit is the ability to remotely trigger your Nikon camera's shutter, especially with advanced control over the half-press function when used with compatible PocketWizard radios, leading to quicker response times.

No, it is specifically designed for Nikon cameras that feature a 10-pin remote terminal. Please check the compatibility list in the guide for supported models.

To use its advanced features, you need a compatible PocketWizard transceiver (like a MultiMAX with ACC port or FlexTT5). For some older PocketWizard units, the included MSMM adapter is required.

The cable itself does not provide TTL functionality. You need a compatible PocketWizard transceiver that supports TTL pass-through for your specific camera model.

The pre-trigger function keeps the camera's shutter half-pressed, maintaining focus and exposure. This continuous state consumes camera battery power at a significantly higher rate than normal standby mode.

The MSMM (stereo to mono miniphone adapter) is required when using this cable with older PocketWizard radios such as the Plus II or older MultiMAX units that have a mono 3.5mm input.

The PocketWizard N10-ACC cable has a length of 0.915 meters (approximately 3 feet).

Ensure the cable is securely connected to both the camera and the PocketWizard transceiver. Verify that the PocketWizard transceiver is powered on, correctly set up, and transmitting. Check camera settings for remote operation and ensure the correct input/output ports are used.

Confirm you are using a compatible PocketWizard transceiver (e.g., MultiMAX with ACC port, FlexTT5) that supports independent half-press control. Ensure the cable is connected to the ACC port if applicable. Verify that the half-press function is enabled in your PocketWizard setup.

This is likely due to the pre-trigger function being continuously active. Disable the remote zone or pre-trigger setting on your PocketWizard transceiver when not actively using it to conserve battery power.

Double-check that your camera model is listed in the compatibility list for the N10-ACC. Ensure you are aligning the connector correctly; it should only fit one way.