Best current price£2.32from Travis Perkins
Shopping.co.uk recommended and popular offers
Travis Perkins£2.32Visit shop Solder Ring Fitting P12 22 x 22 mm Elbow 90Deg
Visit shop1 offer from £2.32
View price history by clicking the chart icon.
This guide is for plumbers and DIY enthusiasts working with copper pipe systems who need a reliable 90-degree angle connection. The Plumbright Solder Ring P12 22mm Elbow Fitting offers a quick and secure connection due to its pre-installed solder ring, ensuring a watertight seal. A minor caveat is the requirement for proper soldering technique and heat application for optimal performance.
| Model Part Number | 24016504 |
|---|---|
| Brand | Plumbright |
WRAS (Water Regulations Advisory Scheme) approval signifies that the product has been tested and meets the stringent standards for water quality, safety, and performance required by UK water regulations.
No, this fitting is designed for water and heating systems only. It is not certified or intended for use with gas installations.
The fitting comes with a pre-installed solder ring, which should provide sufficient solder for a good joint. However, applying a small amount of flux to the pipe ends before assembly is often recommended to ensure optimal solder flow and a clean joint.
The fitting is manufactured from high-grade copper, gunmetal, or dezincification resistant (DZR) brass, ensuring durability and resistance to corrosion.
Solder ring fittings are generally quicker and easier to install as they have the solder pre-positioned, reducing the risk of an incomplete joint and ensuring a more consistent result, especially for less experienced installers.
Once a solder ring fitting has been heated and the solder has melted, it cannot be reliably reused. It is designed for a single, permanent installation.
Ensure the pipe and fitting are clean and free of oxidation. Use flux if not already applied. Ensure sufficient heat is applied evenly to both the pipe and fitting. Verify the solder ring has not been dislodged or damaged.
The joint may not have been heated sufficiently or for long enough, or the solder ring may not have fully flowed. The joint will need to be cut out and re-soldered.
Check for any burrs or damage on the pipe end. Ensure the pipe is perfectly round. Gently clean the inside of the fitting if any debris is present.
Setup:
Compatibility:
Care:
