AK Interactive Magnet Standard Density CA Glue 3g - AK12032

This 3g tube of standard density CA glue is best suited for small parts and detailed work due to its fast-setting nature and small quantity. For larger surfaces, a larger volume or different type of adhesive might be more appropriate.

The bottles are intentionally not filled to 100% capacity. This headspace allows for proper flow of the adhesive and prevents premature curing or issues with dispensing.

While the bond is strong in seconds, full curing can take up to 24 hours for maximum strength, depending on the materials and environmental conditions.

Yes, it can be used on clear plastics, but apply sparingly to avoid frosting or clouding the surface. Test on a scrap piece first if possible.

When stored properly in a cool, dry place with the cap tightly sealed, the glue typically maintains its effectiveness for about 6-12 months.

Yes, it forms a strong bond on most metal surfaces. Ensure both metal parts are clean and free from oils or coatings for the best adhesion.

Wipe up fresh spills immediately with a dry cloth. If the glue has cured, it can be carefully scraped off or removed with an acetone-based cleaner, testing the cleaner on your workbench surface first.

Check if the nozzle is clogged. Carefully clear it with a pin. Ensure the cap was properly sealed after the last use.

Ensure surfaces are clean, dry, and free from dust, oil, or grease. Apply a thin, even layer of glue. Hold parts firmly together until the bond sets (usually a few seconds).

This is typical of CA glues. Apply in short bursts and try to minimize movement once parts are joined. Ensure you are using the standard density as intended for small parts.

Do not attempt to pull bonded skin apart forcefully. Soak the affected area in warm, soapy water and gently try to roll or peel the skin apart. Petroleum jelly or nail polish remover (acetone-based, use with caution and test on skin first) can sometimes help dissolve the glue.