Faithfull Cloth Sanding Belt - 560 x 100mm 60G

The belt is made from aluminium oxide grit bonded with resin onto an X-Weight cloth backing.

This belt is 60-grit, suitable for stock removal and initial finishing stages.

Yes, it is suitable for both ferrous metals and hardwoods.

The dimensions are 560mm in length and 100mm in width.

It means the belt can be run effectively in either direction on the machine, offering flexibility in use.

You need to check if your specific sanding machine is designed to use belts measuring 560mm x 100mm. Always refer to your machine's manual.

The lifespan depends heavily on the material being worked, the pressure applied, and the duration of use. As a consumable, they will eventually wear out and require replacement.

Ensure the belt is fitted correctly and in the right direction. Check that pulleys are clean and aligned. Adjust the tracking mechanism on your sanding machine according to its manual.

Verify that the belt size and type are appropriate for your machine and application. Avoid applying excessive pressure. Ensure the workpiece is not overheating the belt.

Check that the correct grit is being used for the material. Ensure the machine is running at an appropriate speed for the material and belt. Clean any debris from the belt surface if possible, though often dulling indicates replacement is needed.

This can be due to a damaged belt joint or debris trapped between the belt and the workpiece. Inspect the belt for damage and ensure the machine's contact surfaces are clean.