Tefal Steam Generator Iron Boiler Cap & Drawer - CS-00112641

The frequency depends on your water hardness and usage. Consult your Tefal iron's user manual. Typically, the drawer should be emptied and rinsed regularly (e.g., after every few uses or when the iron indicates), and the cap/drawer itself should be inspected for wear and replaced if damaged.

This part (CS-00112641) is designed for specific Tefal steam generator iron series including Compact Anti-Calc, Express, Pro-Express, and Pro-Minute GV models, and is confirmed for use in the GV7750. Please check your iron's model number against the compatibility list in the product description or your iron's manual to be certain.

Its primary function is to collect limescale from the water in a separate, accessible compartment, preventing it from entering and damaging the main steam generator boiler system. This helps maintain steam quality and extends the iron's lifespan.

It is highly recommended to use genuine Tefal replacement parts like the CS-00112641. Generic parts may not fit correctly, may not be made of suitable materials, and could potentially damage your iron or not perform as effectively.

First, ensure the boiler cap & drawer is clean and correctly installed. If the problem persists, it might indicate a blockage further within the iron's system or that a deeper descaling procedure for the main boiler is needed, as outlined in your iron's user manual.

Your iron's model number is usually located on a label on the underside of the iron, the base, or near the power cord. It might be listed as 'Commercial Reference' or 'Model'.

Ensure the iron is completely cool. There might be limescale build-up acting as a seal. Try gently wiggling it while unscrewing. If very stubborn, consult your iron's manual for specific removal tips or contact customer support.

Check that the cap/drawer is securely tightened and properly seated. Inspect the seal or gasket on the cap/drawer for damage and replace the part if the seal is compromised.

Verify that the new cap/drawer is the correct replacement part for your model and has been installed correctly. Ensure the water tank is filled and the iron has reached its operating temperature. Check for any blockages in the steam vents.

This cap/drawer is designed to collect scale *from* the water. If scale is inside the main boiler itself, a deeper descaling process specific to your iron model may be required, following the manufacturer's instructions.