Bartoline Teak Oil - Gold

Reapplication frequency depends on exposure. For outdoor furniture, recoat annually or when the wood begins to look dry or lose its water repellency. For indoor furniture, reapply as needed based on appearance.

While primarily formulated for hardwoods like Oak and Teak, it can be used on softer woods. However, results may vary, and it might require more frequent application as softwoods absorb oil differently.

Allow a minimum of 24 hours between coats for best results and proper oil penetration.

Immediately after use, wash all cloths thoroughly with soapy water. Spread them out flat to dry outdoors, away from any ignition sources, before disposing of them.

No, the surface must be bare wood. Existing varnish or paint must be completely removed by sanding before applying the Teak Oil.

While it helps protect the wood from weathering, it does not contain specific UV inhibitors. Prolonged direct sunlight may still cause fading over time.

Teak Oil replenishes essential oils in hardwoods, preventing drying, cracking, and greying. It enhances the wood's natural beauty and provides protection against the elements, resulting in a durable, natural matt finish.

Ensure excess oil was fully removed after each coat and that the wood was uniformly prepared before application. Apply another thin coat if necessary, removing excess promptly.

This indicates excess oil was not removed. Lightly sand the surface with fine-grit sandpaper and wipe clean. Apply a very thin final coat if needed, ensuring all excess is removed.

The wood surface might be too smooth or previously sealed. Lightly abrade the surface with sandpaper to improve oil absorption. Ensure the surface is completely dry before application.

Test the oil on an inconspicuous area first to gauge the final color. The color deepens with subsequent coats. If too dark, attempt to remove excess oil while still wet or consider a lighter finish product.