Polypipe 110mm Soil 135deg Offset Bend Double Socket (Ring Seal x Solvent) Grey SB403G

A 135° offset bend is used to create a specific change in direction within a soil and waste pipe system, often to navigate around obstacles or to connect pipes at an unusual angle while maintaining efficient flow.

This fitting is designed for use with 110mm PVC-U soil and waste pipes. While it offers double socket connection, always ensure compatibility with the specific pipe material and system standards.

The ring seal connection is a push-fit system using a rubber gasket for a watertight seal, offering ease and speed of installation. The solvent weld connection uses a primer and cement to create a permanent, fused bond between the pipe and fitting.

For ring seal connections, silicone lubricant is recommended. For solvent weld connections, you will need PVC primer and solvent weld cement, along with a pipe cutter and potentially a deburring tool.

This fitting is designed for standard soil and waste applications. It is not typically rated for high-temperature or high-pressure hot water systems.

For general cleaning, a damp cloth is sufficient. If solvent cement or primer is accidentally spilled, clean it off promptly with appropriate solvents, ensuring they are compatible with PVC-U.

The fitting has a diameter of 110mm. The '135° Offset' refers to the specific angle of directional change it provides.

Ensure the ring seal is correctly seated and not damaged. Apply a silicone lubricant to both the pipe spigot and the inside of the seal.

Ensure the surfaces were properly prepared (cleaned, primed, and cemented) and held during the initial curing period. Re-joint if necessary, ensuring all steps are followed precisely.

Double-check measurements and the orientation of the offset bend. Ensure no other components in the line are incorrectly installed.

Inspect the pipework visually if possible. If a blockage is suspected, use appropriate drain clearing tools carefully to avoid damaging the fitting or pipe.