Tetrosyl Chassis Paint - Black - 5000ml

It can be applied to most suitably prepared metal surfaces, commonly used on vehicle chassis components.

The paint is handleable in approximately 1 hour and hard dry in 5 hours at 20°C. Recoating is possible after 16 hours.

Yes, once fully cured, it is resistant to petrol, derv, oil, and grease.

No, thinning is not required for brush application.

The approximate coverage is 10-12 square metres per litre.

Store in a cool, dry place away from heat sources. It is subject to regulations for highly flammable liquids, so store accordingly.

This product is primarily designed for metal surfaces. Compatibility with plastics should be tested on a small, inconspicuous area first, as it may not adhere well or could damage certain plastics.

Ensure the surface was thoroughly cleaned, degreased, and free from rust before application. Re-prepare the surface and reapply.

Apply thinner coats and use a good quality brush. Ensure consistent brush strokes.

Check if the paint was thinned correctly for cold spray (5-10%). Ensure adequate ventilation and that the spray gun is set up appropriately.

Ensure application is within the recommended temperature range (10-25°C) and humidity levels are not too high.