Polypipe Soil 92.5deg Double Branch - White

The primary use is to create a 92.5-degree junction in a 110mm soil and vent pipe system, allowing two waste pipes to connect to a single stack.

This fitting is designed for solvent weld jointing, requiring specific PVC solvent cement for a secure, leak-proof connection. The push-fit ring seal system is for pipe connection, but the branch connection itself is solvent weld.

While made of durable PVC, it's primarily designed for above-ground soil and vent systems. Specific underground drainage components may be required for subterranean applications.

The dimensions are approximately H:150.0 x W:292.0 x D:269.0 cm.

The fitting is white.

It is designed to be compatible with Polypipe's own soil systems and standard 110mm PVC soil pipes. Compatibility with other brands should be confirmed.

While installation typically follows standard plumbing practices for PVC soil systems, always refer to the specific instructions provided by Polypipe or the solvent cement manufacturer for best results.

Ensure the correct PVC solvent cement was used and applied properly. Check that the pipe was fully inserted and held in place during the curing process. Re-joint if necessary, ensuring surfaces are clean and dry.

Verify that both the pipe and the fitting socket are clean and free of obstructions. Ensure you are using a 110mm pipe as intended. If using a push-fit system, ensure the seal is correctly seated.

Confirm the 92.5-degree angle has not created an unintended pooling point. Check for any internal obstructions or blockages in the connected pipes or the main stack. Ensure proper ventilation of the system.