Water Hammer Arrestor - Midbrass

Water hammer is the banging noise that occurs in pipes when water flow is abruptly stopped or changed, creating a pressure surge.

Install the arrestor as close as possible (within 1.5 meters) to the appliance or fixture causing the water hammer.

Yes, the Midbrass Water Hammer Arrestor can be installed vertically or horizontally.

If your water system pressure exceeds 60psi (4 Bar), a pressure-reducing valve is recommended before the arrestor.

The arrestor uses standard 3/4"M-3/4"F compression fittings for washing machine valves.

For severe water hammer, consider installing multiple arrestors in-line for increased protection.

No, this arrestor is specifically designed to address water hammer. Other plumbing noises may have different causes.

The Midbrass Water Hammer Arrestor is built for long-term use, providing lasting protection against water hammer.

Ensure the arrestor is installed within 1.5m of the source. If the issue is severe, install additional arrestors. Also, check for a pressure-reducing valve if your system exceeds 60psi.

Tighten connections, but avoid overtightening. Ensure fittings are properly seated and consider using Teflon tape if needed.

Check for any blockage in the arrestor or fittings. Ensure the water supply valves are fully open. If the issue continues, contact a plumber.