Orac Decor Coving Moulding - C217F - LUXXUS

The Orac Decor C217F coving is made from Purotouch®, a high-density polyurethane material known for its lightness, strength, and dimensional stability.

For standard interior use, Decofix Pro is recommended. For damp environments like bathrooms or kitchens, it is essential to use Decofix Power adhesive for optimal adhesion and longevity.

The moulding measures 200 cm in length, 10.3 cm in height, and 15.6 cm in width.

Yes, the profiles are supplied with a pre-painted white undercoat, ready for you to apply your desired topcoat of paint.

The minimum bending radius for the C217F coving is 380 cm, meaning it can accommodate gentle curves but is not suitable for sharp bends.

Yes, the lightweight nature of Purotouch® and the availability of specific adhesives make it a DIY-friendly product. However, clean cuts and proper adhesive application are crucial for a professional finish.

Absolutely. The primer coat is designed to accept standard water-based or acrylic paints, allowing you to match the coving to your interior colour scheme.

Ensure the correct Decofix adhesive was used and applied generously. Verify the surface was clean, dry, and properly prepared. Reapply adhesive and secure firmly.

Ensure precise, clean cuts were made. Apply Decofix Ultra adhesive to the joining edges for a strong, seamless bond. Sand lightly if necessary after curing and touch up paint.

Check that sufficient adhesive was used along the entire length. Ensure the wall/ceiling surface is flat. Use temporary supports while the adhesive cures if necessary.

Ensure the pre-painted primer coat was fully dry. Apply thin, even coats of paint rather than one thick layer. Use a high-quality paint suitable for mouldings.