StoneCare4U Essential Satin Finish Slate Sealer 5L 2 Pack - Grey

While the surface is dry to the touch within 45-60 minutes between coats, full curing can take up to 72 hours, after which the surface can be subjected to normal use. Avoid heavy traffic or cleaning during the curing period.

This sealer is designed for porous natural stones and enhances their natural colors. It may alter the appearance of polished surfaces, so it is essential to test in an inconspicuous area first. It is primarily intended for unpolished, natural finishes.

A minimum of two coats is recommended for optimal protection. Additional coats can be applied to achieve a higher gloss finish if desired. Ensure adequate drying time between each coat.

Coverage varies depending on the porosity and texture of the stone. As a general guideline, expect coverage of approximately 5-10 square meters per liter per coat. Always refer to the product packaging for the most accurate coverage information.

Yes, it is suitable for internal natural stone surfaces, including those in bathrooms, provided the stone is porous and compatible. Ensure good ventilation during application and curing.

Clean sealed slate surfaces with a soft cloth or mop and warm water. For tougher stains, use a pH-neutral stone cleaner. Avoid using acidic or abrasive cleaners as they can damage the sealer over time.

If the product is still wet, wipe it up immediately with an absorbent cloth. If it has dried, you may need to use a specialized stone sealer remover. Always mask off areas not intended for treatment before starting.

This could be due to moisture trapped beneath the sealer. Ensure the surface was completely dry before application and that the temperature was within the recommended range. If this persists, it may indicate an incompatibility with the stone. Consider professional advice.

Apply subsequent coats thinly and evenly, using consistent strokes. Using a micro-fibre mop or roller can help achieve a more uniform finish. Recoat in the opposite direction to the previous coat.

Ensure at least two coats have been applied and have fully cured. The surface may require an additional coat if a high level of repellency is desired. Check that the correct product for the stone type has been used.

Try to carefully remove the excess product while it is still wet using an absorbent cloth. If the product has dried, it may require gentle abrasion or a specific stone cleaner designed to remove sealer buildup, followed by reapplication.