DrayTek VigorSwitch P2100 - 8-Port PoE+ Managed Switch

The default IP address is usually 192.168.1.2. Refer to the product documentation or the label on the switch for confirmation.

There is a reset button on the switch. Press and hold the reset button for about 10 seconds. This will reset the switch to its factory default settings. Note: this will erase all configurations.

The total PoE power budget is 140W.

Yes, you can manage the switch remotely using the VigorACS cloud management platform, DrayTek's Central Switch Management for Vigor routers, or the switch's web interface.

Use standard Cat5e or Cat6 Ethernet cables for Gigabit Ethernet connections.

Yes, the VigorSwitch P2100 supports Jumbo Frames up to 9000 bytes.

Please refer to the warranty information that came with the product or visit the manufacturer's website for specific warranty details.

Check if PoE is enabled on the corresponding port. Verify the PoE budget isn't exceeded. Ensure the connected device supports PoE.

Verify the switch's IP address. Check your computer's IP address and subnet mask to ensure they are on the same network. Try resetting the switch to factory defaults.

Check the network cables. Check for broadcast storms or other network traffic issues. Examine the switch's QoS settings. Upgrade the switch firmware.

Double-check VLAN configuration, including port assignments and trunking. Ensure devices are connected to the correct VLANs. Verify that routing between VLANs is correctly configured (if applicable).