Tetrion Powerfil 2K 2 Part Body Filler - 2kg x 2 - TPW200

Yes, Tetrion Powerfil 2K is compatible with most plastics. We recommend performing a small test patch on an inconspicuous area first.

Yes, for the best finish, you should sand the cured filler until smooth and apply a suitable primer before painting.

Use a small plastic card or board to measure out a dollop of filler and a small, thin ribbon of hardener, adjusting until you achieve the 50:1 approximate volume ratio.

Yes, it provides a hard, durable, and water-resistant finish once fully cured.

No. Once the hardener is mixed with the filler, the chemical reaction is irreversible and the product must be used immediately.

While it is designed for versatility, for very deep holes, it is best to apply in layers, allowing each to cure slightly before adding the next to ensure deep-set hardness.

This is likely due to an incorrect mixing ratio or insufficient mixing. Ensure you use the 1:50 ratio and mix until the color is completely uniform.

Working in high temperatures can accelerate the cure time. Try mixing smaller batches at a time or work in a cooler environment.

The surface may have been greasy or damp. Ensure the substrate is cleaned with a degreaser and thoroughly dried before application.