Best current price£8.18from B&Q
Shopping.co.uk recommended and popular offers
B&Q£8.18Visit shop B&Q - ChemtronicsSoder-Wick No Clean Desoldering Braid Yellow Label 1.5mm X 1.5M
Visit shop2 offers from £8.18
View price history by clicking the chart icon.
The Chemtronics Soder-Wick No Clean Desoldering Braid is an essential tool for electronics technicians, hobbyists, and repair professionals who require precision solder removal on delicate printed circuit boards (PCBs). This high-performance wick stands out for its patented non-corrosive, halide-free organic flux formula that accelerates desoldering by up to 40% compared to traditional braids. While this product excels at speed and safety, users should note that the 'no-clean' designation still recommends inspection under magnification to ensure no small solder bridges remain in dense component areas.
| Model Part Number | 60-2-5 |
|---|---|
| Brand | Chemtronics |
The flux is designed to be non-conductive and non-corrosive, so cleaning is typically not required; however, you may clean with an electronics-grade solvent if your specific quality standards require it.
Yes, this braid is fully compatible with both leaded and lead-free solder alloys.
Yes, the packaging is manufactured with static-dissipative materials to minimize the risk of ESD damage to components.
This specific variant comes in a 1.5-meter length.
This product features a 1.5mm width, ideal for fine-pitch and standard electronic work.
Ensure the iron tip is clean and freshly tinned, or verify that the iron is set to the correct operating temperature.
Apply a small amount of additional flux to the joint or increase the iron temperature slightly to ensure the solder remains fully molten.
To ensure peak performance, keep the braid stored in its original ESD-safe bobbin to prevent oxidation and moisture absorption. Always use an iron with a temperature-controlled station; set the temperature slightly higher than the melting point of the solder used (typically 350-375 Celsius for lead-free applications). Ensure the braid is not held against the board for too long to prevent overheating the PCB substrate. After use, trim the saturated portion of the wick with sharp wire cutters to expose a fresh, clean segment for the next joint.
