Great Lakes Erie 6 Person UV Hot Tub 200 x 200cm

It is generally recommended to drain and refill your hot tub every 3-4 months, depending on usage frequency and water care practices.

UV purification uses ultraviolet light to inactivate microorganisms like bacteria and viruses, providing an extra layer of sanitation and helping to keep water clear with fewer chemicals.

While the hot tub is designed for outdoor use, it's crucial to follow the manufacturer's specific winterization procedures if temperatures are expected to drop below freezing to prevent damage.

Remove the filter and rinse it thoroughly with a garden hose. For deeper cleaning, use a filter cleaning solution. Inspect for damage and replace if necessary, typically every 1-2 years.

The Great Lakes Erie UV Hot Tub requires a dedicated GFCI-protected electrical circuit. Specific voltage and amperage requirements should be confirmed in the product manual.

Most jets can be adjusted by rotating the face of the jet or by moving a small lever on the jet body to control flow and direction. Refer to your manual for specific jet types.

Check the circuit breaker, ensure the cover is on, and verify the thermostat settings. Ensure the water level is adequate.

Verify that the correct jets are open. Check the filter for clogs and clean or replace if necessary. Ensure the pump is running.

Check and clean the filter. Ensure the UV and ozone systems are operational. Test and balance water chemistry, and consider a shock treatment if necessary.

Check electrical connections to the lighting system. Consult the manual for specific troubleshooting steps for the lighting control module.

Ensure the hot tub's Bluetooth is enabled and in pairing mode. Turn off and on the Bluetooth on your device and try reconnecting. Check the manual for pairing instructions.