Setup, Compatibility & Care
Compatibility
This driveshaft is compatible with the following vehicles produced between 2005 and 2012:
- Volvo C30
- Volvo C70
- Volvo S40 II
- Volvo V50
- Ford Focus C-Max
Installation
- Secure the vehicle on jack stands and remove the front right wheel.
- Disconnect the ball joint and strut assembly to allow enough clearance for shaft removal.
- Remove the old driveshaft, ensuring no debris enters the transmission seal.
- Slide the new D2P driveshaft into the transmission, ensuring the retention clip clicks into place.
- Reassemble the suspension components and tighten all bolts to the torque specifications provided in your vehicle service manual.
Care
Regularly inspect the protective rubber boots for any cracks or tears. If the boot is compromised, road debris can enter the joint and cause rapid internal wear.