Lezyne Micro Drive 800+ and Strip Drive 300+ LED Bike Light Set

The front Micro Drive 800+ can last up to 35 hours in its most efficient mode (e.g., economy or a specific flash pattern). Runtime will be shorter in higher output modes.

The rear Strip Drive 300+ can achieve up to 80 hours of runtime in its most efficient mode, such as a lower-power flash setting.

Typically, these types of lights are not designed for use while charging, especially at higher brightness levels, to prevent overheating and ensure proper charging.

Charging indicators vary by model, but usually, an LED on the light will change color or turn off when the charging cycle is complete. Refer to the specific manual for your light.

Yes, the Lezyne Micro Drive 800+ and Strip Drive 300+ LED Bike Light Set typically includes the necessary mounting hardware for both front and rear lights.

IPX7 means the lights are protected against the effects of temporary immersion in water. They can be submerged in up to 1 meter of water for up to 30 minutes.

The set usually includes the necessary USB-C charging cable. However, it's always good to confirm with the product listing or packaging.

Ensure the battery is charged. Connect the light to a USB-C power source and verify it is charging. Check that the light is properly seated on its mount, if applicable.

Verify the USB-C cable is functioning correctly by testing it with another device. Ensure the charging port on the light is clean and free of debris. Try a different USB-C power source.

The battery may be low. Charge the light fully. If the issue persists after a full charge, the battery may be degraded and require service or replacement.

Immediately discontinue use and dry the light thoroughly. Inspect all seals and O-rings for damage. If damage is found, contact customer support for repair or replacement parts. Do not attempt to use or charge a light that has significant water ingress.