XL Joinery Internal Salerno Oak Door - 1981 X 838 X 35mm

No, the door is supplied unfinished and without ironmongery. Hinges, handles, and locks need to be purchased separately.

Yes, provided you apply a suitable moisture-resistant finish and ensure good ventilation. The door itself is not inherently waterproof.

You can typically trim up to 6mm from the top, bottom, and sides of the door. However, always check the specific trimming guidelines for this model and ensure you do not cut into the decorative groove details.

The product information specifies it is an oak door, implying a solid or engineered wood construction suitable for internal use.

Yes, XL Joinery offers matching fire doors within the Salerno range to ensure design continuity.

Specific warranty information is not provided in the product description. Please refer to the retailer or manufacturer's warranty documentation for details.

Installation is possible for individuals with basic carpentry skills. However, if you are unsure, it is recommended to hire a professional joiner to ensure a correct and safe installation.

Check for obstructions, ensure hinges are properly aligned and tightened, and verify the door is not rubbing against the frame due to humidity changes. Minor adjustments to hinges or a light sanding of the rubbing edge may be necessary.

Ensure the door was properly prepared and cleaned before finishing. Apply thin, even coats of paint or stain, allowing adequate drying time between coats. If peeling occurs, strip the affected area, prepare the surface, and reapply the finish.

Tighten any loose screws on the hinges. If the noise persists, consider lubricating the hinge pins with a light oil or graphite powder.