Metsä Wood - Smooth Planed Whitewood Spruce Stick Timber - 2.4M - 94mm - 69mm

'PSE' stands for Planed Square Edge. It means the timber has been machined on all four sides to achieve consistent dimensions and a smooth, square finish, making it easier to work with and providing a neater appearance than rough-sawn timber.

This whitewood spruce timber is suitable for sheltered outdoor applications or if properly treated with an exterior-grade wood preservative, paint, or stain. For untreated outdoor use, it will be susceptible to weathering, moisture damage, and potential decay over time.

While the timber is planed smooth, a light sanding with fine-grit sandpaper (e.g., 180-220 grit) can further improve the surface for optimal paint or stain adhesion and a professional-grade finish. Always clean off any sanding dust thoroughly.

Standard wood screws or nails are suitable. For best results and to prevent splitting, especially near edges, it's recommended to pre-drill pilot holes for screws. Choose fastener lengths appropriate for the thickness of the timber and the depth of penetration required for your project.

This is a general-purpose PSE timber. For structural, load-bearing applications, it is crucial to consult local building codes and a qualified engineer to ensure compliance and safety, as specific graded timber might be required.

To prevent warping or twisting, store any unused timber flat on a level surface (e.g., on battens or risers) in a cool, dry, and well-ventilated area. Avoid direct sunlight, excessive humidity, or rapid temperature changes.

This can occur due to improper storage or rapid environmental changes. Ensure timber is stored flat on a level surface in a dry, well-ventilated area away from extreme temperature or humidity fluctuations. Allow timber to acclimatize to the project environment for a few days before use.

Although planed, a light final sanding with fine-grit sandpaper (e.g., 180-220 grit) prior to applying primer or finish can further refine the surface and improve adhesion. Always ensure the surface is completely clean and dust-free before finishing.

This is common with timber. To prevent splitting, particularly when working close to the ends or edges, always pre-drill pilot holes for screws and nails. Ensure the pilot hole diameter is slightly smaller than the fastener's core diameter.