Kenable Ethernet Network Cable Plugs - Cat5e/Cat6 - 10 Pack

No, these Kenable RJ45 connectors are specifically designed for stranded LAN cables and are not suitable for solid core cables.

These plugs are compatible with standard RJ45 crimping tools designed for modular connectors.

The pass-through design allows wires to be pulled completely through the connector, enabling a tighter pull-down over the cable jacket. This reduces the distance between wire twists and the contacts, which can lead to cleaner signal integrity and potentially improved performance.

While designed for Cat5e/Cat6, they may be usable with certain Cat6a cables if the conductor gauge is within the specified limits (max 24 AWG). Compatibility with thicker Cat7 cables is unlikely.

These plugs are suitable for conductors with a maximum gauge of 24 AWG.

This pack is supplied with 10 RJ45 connectors.

Yes, the pass-through design allows wires to exit the front of the connector, so you can visually confirm the correct wiring sequence before crimping.

Double-check the wire order (T568A/T568B) on both ends of the cable. Ensure all wires are properly seated in their respective channels and are making contact with the pins after crimping. Verify the cable is for stranded wire and that the crimping tool is functioning correctly.

Inspect the crimp for a solid connection. Ensure the outer jacket is properly seated within the rear of the connector for strain relief. Re-terminate the cable, paying close attention to wire order and clean stripping of the jacket.

Ensure you are using stranded cable, as these connectors are optimized for it. Verify that the individual wires are straight and not bent or frayed before insertion. Some minor resistance is normal.