Best current price£4.99from eBay
Shopping.co.uk recommended and popular offers
eBay£4.99Visit shop 67cm Walnut Med Wood S/A Vinyl Fablon (2008024) order per metre sent as 1 roll
Visit shop
B&Q£62.99Visit shop B&Q - Walnut Medium Wood (8024) Self-Adhesive Furniture Wrap (L)15M (W)675mm
Visit shop9 offers from £4.99 - £62.99
View price history by clicking the chart icon.
The d-c-fix Furniture Wrap in Walnut Medium is designed for homeowners and DIY enthusiasts looking for a cost-effective way to refresh surfaces like kitchen cabinets, furniture, and tabletops. Its key benefit is the ease of application and a durable, wipe-clean finish that mimics authentic woodgrain. A notable caveat is that it's not suitable for direct contact with hot pans, requiring caution around heat sources.
| Model Part Number | 200-8024-15 |
|---|---|
| Brand | d-c-fix |
The film adheres best to flat, smooth surfaces. Textured surfaces may result in an uneven finish and compromised adhesion.
The film is heat resistant up to 70°C (158°F). It is not suitable for direct contact with hot pans or cookware.
Wipe the surface with a damp cloth. For spills, wipe them up immediately to avoid staining. Avoid abrasive cleaners.
This product is designed for indoor use. Outdoor exposure to UV rays and weather may cause premature degradation and color fading.
The d-c-fix Furniture Wrap comes with a 1-year guarantee.
Yes, but it is highly recommended to use a sealant around the edges, especially near sinks or shower areas, to prevent water from seeping underneath and lifting the vinyl.
Ensure the surface is clean and smooth. Apply slowly, peeling the backing paper gradually while smoothing the film with a felt edge smoother from the center outwards. Repositioning during application also helps.
Gently lift the film back to the bubble and reapply, smoothing firmly with a felt edge smoother. For stubborn bubbles, a small pin prick at the edge of the bubble may allow air to escape.
Ensure the surface is thoroughly cleaned and dried. Reheat gently with a hairdryer and press down firmly. For porous surfaces, ensure they are properly sealed or primed.
Apply a thin bead of sealant around the edges, especially in areas exposed to moisture. Ensure edges are pressed down firmly after application.
Use a sharp utility cutter or craft knife and a metal ruler for straight edges. Ensure the film is flat on a cutting mat for precise cuts.
Gently heat the film with a hairdryer on a medium setting. This softens the adhesive, making it easier to peel off slowly at a low angle.
Setup: Ensure the surface is clean, dry, and smooth. Measure and cut the film using the grid on the reverse. Peel back a small section of the backing paper and carefully align the film. Slowly peel the backing paper while smoothing the film onto the surface with a felt edge smoother, working from the center outwards to avoid air bubbles. The film is repositionable during application for minor adjustments.
Compatibility: This vinyl film is suitable for any flat, non-porous surface. This includes finished wood, laminate, metal, glass, and painted walls (ensure paint is well-adhered).
Care: Wipe clean with a damp cloth. For spills, wipe up immediately to prevent staining. Avoid using abrasive cleaners or scouring pads. For edges near water sources like sinks or hobs, apply a sealant to prevent moisture from lifting the vinyl. A hairdryer can be used to gently warm and stretch the film over curved edges, and also to assist in its removal when needed.
