A premium quality plasticiser designed to improve the workability of all Portland cement based mor...A premium quality plasticiser designed to improve the workability of all Portland cement based mortars and to increase their resistance to freeze-thaw cycles. Conforms to EN 934-3.
Bond It LIQUID MORTAR PLASTICISER eliminates the need for additional lime to be added to the mix. Entrains air increasing workability and frost resistance. Gauging water requirements are reduced minimising the risk of cracking or crazing because of shrinkage while drying.
Uses:
For addition to brick mortars, cement renders, pointing mixes.
Replacing lime in the above mixes.
Application:
Shake well before use. Use at y
This guide is for builders, contractors, and DIY enthusiasts using Bond It 25L Liquid Mortar Plasticiser. It improves the workability of cement-based mortars and enhances freeze-thaw resistance, eliminating the need for additional lime. Keep in mind that while it improves mortar performance, proper mixing and application techniques are still essential for optimal results.
All features
Brand
Bond it
Extended Product Information
FAQs
What is the shelf life of Bond It Liquid Mortar Plasticiser?
Refer to the product label for the specific shelf life. Generally, it is best used within 12 months of the manufacturing date if stored correctly.
Can I use this product with all types of cement?
Yes, Bond It Liquid Mortar Plasticiser is designed for use with all Portland cement-based mortars.
Do I need to add lime when using this product?
No, Bond It Liquid Mortar Plasticiser eliminates the need for additional lime.
How do I store the plasticiser?
Store in a cool, dry place, away from direct sunlight and extreme temperatures.
What happens if I use too much plasticiser?
Overuse can result in mortar that is too soft and slow to set. Always follow the recommended dosage.
Is Bond It Liquid Mortar Plasticiser safe to use?
Always wear appropriate protective equipment, such as gloves and eye protection, when handling the product. Refer to the safety data sheet for detailed safety information.
Troubleshooting
Mortar is too soft or takes too long to set.
Reduce the amount of plasticiser used or check the cement-to-aggregate ratio.
Mortar appears to crack during drying.
Ensure proper water content and avoid rapid drying by covering the applied mortar.
Mortar is difficult to work with.
Make sure you have shaken the product well. The mortar could be mixed with the wrong water to cement ratio.
Pros and Cons
Pros
Improved workability of mortar.
Enhanced resistance to freeze-thaw cycles.
Eliminates the need for lime.
Reduces water requirements, minimizing shrinkage cracking.
Cons
Requires accurate measurement to avoid over-plasticizing.
May alter the setting time of the mortar slightly.
Does not address underlying issues like poor substrate preparation.
Effectiveness depends on proper mixing techniques.
Setup, Compatibility & Care
Preparation: Ensure the product is shaken well before use.
Application: Add the plasticiser to the gauging water before mixing with the cement and aggregate.
Dosage: Use at the recommended rate (see product instructions for specific ratios).
Compatibility: Compatible with all Portland cement-based mortars.
Storage: Store in a cool, dry place, away from direct sunlight.
Care: Follow the manufacturer's instructions for mixing and application to achieve the best results.