Intex Rechargeable Handheld Pool Vacuum - Zr100

A full charge takes approximately 5-6 hours, providing up to 50 minutes of maximum run time.

It is designed for all Intex PureSpa™ models and above-ground pools up to 18 feet in diameter, as well as other smaller pools and hot tubs.

No, for safety reasons, the vacuum should not be used while it is charging.

After use, detach the transparent debris container, empty it, and rinse it along with the debris bags. Allow them to dry completely before reassembling.

Yes, the included lightweight telescoping aluminum pole extends up to 94 inches, allowing it to reach across most pool sizes within its compatibility range.

The vacuum features an automatic shut-off mechanism that will turn it off when it is not submerged, ensuring safety and preserving battery life.

The Intex ZR100 comes with built-in rechargeable batteries that are not designed for user replacement.

Ensure the vacuum is fully charged. Check that the unit is submerged in water; the automatic shut-off prevents operation when dry. Verify the IPX8 waterproof switch is functioning correctly.

Check if the debris container is full and empty it. Ensure the debris bags are clean and properly installed. Verify that the brush head is not clogged with debris. Make sure the vacuum head is fully submerged.

The vacuum may have reached its 50-minute run time limit and needs recharging. It might also have shut off automatically because it was lifted out of the water.

Use the appropriate brush head for the type of debris. Ensure you are moving the vacuum slowly enough over the debris. Empty the debris container frequently to maintain optimal suction.