Tile Rite Big Spin Hurricane Tile Levelling System Starter Kit - 2mm - 3-15mm Tiles

Its main purpose is to prevent 'lippage' (uneven tile edges) during adhesive curing, ensuring adjacent tiles remain perfectly flush and creating a consistent grout line.

The system is designed for tiles ranging from 3mm to 15mm in thickness.

No, the spacer bases are single-use and are designed to snap off after the adhesive cures. The caps, however, are reusable.

This specific system is designed to create an even 2mm grout joint.

Yes, the Big Spin Hurricane caps and protection plates are interchangeable with the standard Big Spin levelling system.

The starter kit contains 150 bases and 50 caps. The number of tiles you can level depends on the size of the tiles and how many edges need levelling simultaneously. For a 600x600mm tile, you would need 4 bases per tile (one for each edge meeting another tile).

It is suitable for large format porcelain, marble, and stone tiles.

Ensure the spacer base is correctly positioned under the edges of both tiles and that the cap is screwed down tightly to apply sufficient pressure. Check that the tile adhesive has not already set before applying the levelling system.

Wait for the adhesive to fully cure. If still difficult, a light tap with a rubber mallet near the base might help, or carefully use a utility knife to score the base at the grout line before snapping.

Clean any excess adhesive or grout from the threads of both the cap and the base. Ensure the base is properly aligned with the cap before turning.

Verify that the correct size spacer base (for a 2mm joint) is being used and that it is positioned consistently between all adjacent tiles.