Best current price£7.19from Bradfords
Shopping.co.uk recommended and popular offers
Bradfords£7.19Visit shop Rawlplug Spare Nozzles For R-Kem-Ii Resin Cartridge (Pack Of 5)
Visit shop1 offer from £7.19
View price history by clicking the chart icon.
Designed for professional contractors and DIY enthusiasts using the Rawlplug R-KEM II anchoring system, these spare mixer nozzles are essential for achieving a perfect chemical blend during installation. They allow you to maximize the utility of your resin cartridges by enabling the reuse of partially used tubes, effectively minimizing material waste. While these nozzles are highly efficient, they are specifically engineered for the R-KEM II series and are not universally compatible with other resin brands or types, necessitating careful system matching.
| Model Part Number | R-S1-NOZ-KEM/5 |
|---|---|
| Brand | Rawlplug |
No, these nozzles are specifically designed for the thread and mixing geometry of Rawlplug R-KEM II resin cartridges.
Remove the used nozzle immediately after application, wipe the cartridge thread clean, and seal the cartridge with its original cap. When you are ready to continue, use a fresh nozzle.
Yes, high temperatures can cause the resin to set faster inside the nozzle. Work efficiently to prevent curing within the mixer.
No, these are single-use components intended to be discarded once the resin inside them has begun to cure.
Ensure the nozzle is threaded properly onto the cartridge. If leaking persists, check the cartridge neck for cracks.
Check if the resin has cured inside the nozzle tip; if so, replace with a new nozzle immediately.
Ensure the nozzle is screwed on tightly and discard the first few milliliters of resin, which may not have been fully blended.
To set up the nozzle, ensure the R-KEM II cartridge nozzle head is free of dried debris. Simply twist the nozzle onto the cartridge thread until it sits firmly in place. Compatibility is strictly limited to R-KEM II systems in 175ml, 300ml, and 410ml sizes. For care, always ensure that if you intend to reuse a cartridge, you remove the nozzle immediately after use. If the resin is left to cure inside the nozzle, it will become permanently blocked and must be discarded. Do not attempt to flush the nozzle with solvents, as they may compromise the integrity of the resin's chemical properties for subsequent anchors.
DeWalt Multi Material Drill Bit - DT6526-QZFrom £8
Lay-Z-Spa Rechargeable Underwater Vacuum - GreyFrom £60
DeWalt Impact Masonry Drill Bit - 5.5mmFrom £5
Westin W2 Finesse-T T&C Rod - 7'1" M 7-21g 2 SecFrom £90
Daiwa Predator D Pike Deadbait - 12' - 3.5LbFrom £40
Duratool SDS Plus Drill Bit - 8mm x 260mm - D03376From £6
Daiwa D Barbel Fishing Rod - 12ft 2.25LbFrom £40
Daiwa Matchman Pellet Waggler Rod - 12' 2PCFrom £40
Laser Grease Gun Hose & Connector - Flexi-hose, 4 jaw connectorFrom £12
Universal Masonry Drill Bit - (Dia)8mm (L)400mmFrom £13
Shimano - FX XT Spinning Rod - 1.80m 3-14gFrom £22
DeWalt Extreme Masonry Drill Bit - 10mm x 120mm - DT6685-XJFrom £3