Draper Electronic Flush Cut Nipper - 130mm

These nippers are designed to cut copper wire up to 1.2mm in diameter.

No, they are specifically designed for soft copper wire and are not suitable for harder materials like steel.

A flush cut means the nipper cuts the wire as close to the surface as possible, leaving minimal or no protruding wire end.

Keep the blades clean and dry, lubricate the pivot point periodically, and avoid cutting materials or wire sizes beyond their specified limits.

The limiter helps prevent the handles from opening too wide, which protects the cutting blades from damage and ensures they align correctly for each cut.

The design is symmetrical and should be comfortable for both right-handed and left-handed users, though the soft grips are a universal ergonomic benefit.

Ensure you are not exceeding the 1.2mm copper wire capacity. Clean the blades thoroughly with a soft cloth. Check for any debris or damage to the cutting edge. If blades appear damaged, they may need replacement.

Clean the pivot point with a dry cloth. Apply a small amount of light machine oil to the pivot and work the handles back and forth to distribute the oil.

Verify the wire is within the specified 1.2mm copper diameter limit. Ensure the wire is positioned correctly at the base of the cutting jaws for a flush cut. The limiter might be preventing a full closure if misaligned; check it is not obstructing the cut.