20 Pack Zinc Plated Hose Clip - 25 to 35mm Diameter - Loops

These hose clips are designed to fit hoses with an outer diameter ranging from 25mm to 35mm.

This product is a pack of 20 zinc-plated hose clips.

It means the threads on the worm screw are pressed outwards, providing a smoother surface contact with the hose, which helps prevent damage compared to clips with internal threads.

They are suitable for general automotive, industrial, and DIY applications. For extremely high-pressure systems, always consult the specific requirements of the application and equipment manufacturer.

The zinc plating offers some corrosion resistance, making them suitable for general marine use. However, for prolonged or direct immersion in saltwater, stainless steel clips are recommended for better longevity.

A flathead screwdriver or a nut driver is typically used to tighten the worm screw mechanism of these hose clips.

These hose clips are manufactured in the UK to DIN 3017 standards.

Ensure the hose diameter is within the 25-35mm range. Check that the screw mechanism is clean and free of debris. If the hose is too soft or worn, it may not provide enough resistance for a tight seal; consider replacing the hose.

The clip may have been overtightened. Loosen the clip and inspect the hose for cuts or deep indentations. Ensure the external threads are properly seated against the hose and not digging in. Use less force on subsequent tightenings.

While zinc-plated, prolonged exposure to moisture or corrosive substances can cause surface rust. For critical applications, consider replacing the affected clip or using stainless steel alternatives if the environment is particularly harsh. Clean the area if it's minor surface rust.

The screw mechanism may have accumulated dirt or grit. Try cleaning the screw slot with a small brush and penetrating oil, then wiping clean. If the issue persists, the clip may be damaged and should be replaced.