Whale Standard Submersible Galley Pump - 12V - 10 LPM - GP1002

Yes, the Whale GP1002 is designed for use in marine (boat) and caravan environments, providing reliable water supply from a fresh water tank.

While technically possible, this pump is specifically designed and optimized for basic single-outlet applications. For multiple taps or higher demand, a pump with a higher flow rate and pressure is recommended.

No, the Whale GP1002 does not have an automatic dry-run shut-off feature. It is crucial to ensure the pump is always submerged when operating to prevent damage. An external water level sensor could be installed for automatic shut-off if desired.

This pump is designed for use with flexible hoses that have an internal diameter of either 10mm or 13mm.

The pump requires a 12V DC power supply. Connect the red wire to the positive (+) terminal and the black wire to the negative (-) terminal of your 12V system. An inline fuse (3-5 amp) and a manual switch should always be installed for safety and control.

No, as a submersible pump, it is designed to be placed directly into the water tank and operates when fully submerged. It does not self-prime from a dry state outside the water.

1. Check the 12V power supply to ensure it's active. 2. Verify that the inline fuse is not blown; replace if necessary. 3. Inspect all electrical wiring for loose connections or corrosion. 4. Ensure the manual switch (if applicable) is in the 'on' position.

1. Check the water tank level; the pump must be fully submerged. 2. Inspect the hose for kinks, blockages, or tight bends. 3. Clean the pump inlet filter (if present) of any debris. 4. Ensure there are no air locks in the system by running the tap for a moment to clear air.

1. Confirm the water tank has sufficient water and the pump is fully submerged. 2. Check for severe blockages in the hose or at the tap. 3. Listen for air being sucked in, which could indicate a loose hose connection allowing air into the system instead of water.

1. Ensure the pump is completely submerged in water; dry running causes significant noise. 2. Check if the pump is vibrating against the tank wall or other surfaces; reposition or secure it if needed. 3. Verify there isn't air trapped in the system or being drawn in through a loose connection.

1. Tighten all hose clips at the pump outlet and faucet connections. 2. Inspect the hose itself for any cracks or punctures. 3. Ensure the hose is correctly seated on the pump's barb fitting.