Sliding Door Hardware Kit - Black

The delivery contains the sliding door hardware kit only, which includes 4 x Sliding rails, 4 x Door stops, 8 x Rollers, 10 x Fixing clamps, 4 x Floor guides, 1 x Barn door track joiner, and other necessary hardware. The door itself is not included.

No, this kit is specifically designed for barn door rails that are 40 mm wide and 6 mm thick. The track joiner requires compatible rails.

You can extend your existing track by using the included barn door track joiner to connect two compatible rails. Each rail end needs to be pre-drilled with 2 holes for proper installation of the joiner.

The maximum load capacity for this sliding door hardware kit is 100 kg.

This kit is suitable for doors that are 91.5 cm in width and have a thickness ranging from 35 mm to 45 mm.

The kit is designed for easy installation and includes mounting accessories. However, it does require pre-drilling holes on the rails for the joiner.

Clean the powder-coated steel components with a slightly damp cloth. Avoid using abrasive cleaners to maintain the finish.

Check for any obstructions on the track. Ensure the rollers are properly seated and clean. Verify that the track is level and securely mounted.

Ensure the rubber gaskets on the rollers are intact and properly positioned. Check that the door stops are functioning correctly to prevent hard impacts. Clean the track and rollers.

Confirm that the door stops are installed correctly at the ends of the track. Ensure the floor guide is properly aligned and secured to prevent the door from swinging outwards.

Re-tighten the screws connecting the track joiner to the individual tracks. Ensure the holes on the tracks were pre-drilled correctly and that the joiner is flush against both track ends.