FloPlast Push Fit Waste Bend - 92.5 Degree x 50mm Grey

While described as 'Push Fit', this product uses a solvent weld joint. This means the pipe is pushed into the fitting socket, but a solvent cement is required to create a permanent, watertight bond. It does not use compression seals like some mechanical push-fit systems.

Measure the actual outer diameter of your waste pipe. This FloPlast fitting requires a pipe with an outer diameter of 53.5mm. If your pipe is labeled '50mm' and measures 53.5mm across, it should be compatible. If it measures 56mm, you need a different fitting.

Yes, the UV-stable finish makes it suitable for outdoor use, protecting it from degradation caused by sunlight exposure.

This is a 92.5-degree waste bend, providing a common angle for waste pipe runs.

You will need a pipe cutter, solvent primer, and solvent weld cement suitable for ABS pipes. No tightening tools are required for the joint itself.

This fitting is specifically designed for ABS solvent weld waste pipes. While it might physically fit other types of plastic pipes, the solvent weld process requires ABS for a secure, permanent bond. Always use the same material type (ABS) for both pipe and fitting when using solvent cement.

WRAS (Water Regulations Advisory Scheme) approval indicates that the product has been assessed and complies with strict water efficiency and public health regulations in the UK.

Ensure pipe and fitting were clean and dry before applying primer and solvent. Re-cut pipe, re-prime, and re-apply solvent cement, ensuring a full push and twist connection. Allow proper curing time.

Verify the pipe's actual outer diameter. This fitting requires 53.5mm OD. If your pipe is larger (e.g., 56mm), this fitting is incompatible. Check for obstructions inside the fitting socket.

Ensure the pipe was cut cleanly and not forced into the fitting at an angle. Avoid overtightening if using any temporary securing methods; this fitting relies on solvent weld strength.