Nextbase Hardwire Kit - Series 2, Black

A hardwire kit provides a permanent and continuous power supply directly from your vehicle's fuse box, freeing up your 12V outlet for other devices. It also enables features like parking mode, which requires constant power even when the ignition is off.

Professional installation is not strictly required, as the kit is designed for a simple plug-and-play setup. However, if you are uncomfortable working with your vehicle's electrical system or accessing the fuse box, professional installation is recommended for safety and peace of mind.

When installed correctly to an appropriate fuse, the hardwire kit should not drain your car's battery. Most dash cams designed for hardwiring have built-in low voltage cut-off protection, which will shut off the dash cam if the car battery voltage drops too low, preventing it from draining completely.

The kit includes components compatible with both standard `ATO/C` (regular size) and smaller `ATM` (mini) blade fuses, covering the most common fuse types found in vehicles.

Yes, while optimized for Nextbase Dash Cams, this hardwire kit can power any dash cam that uses a standard 12-24V DC input and has the compatible power connector. Always verify the voltage requirements of your dash cam.

The LED indicator light confirms that the hardwire kit is receiving power from the fuse box and that power is available to be supplied to the dash cam. If the light is off, it indicates a power issue at the fuse box connection.

The hardwire kit includes a generous 5-meter (approximately 16.4 feet) power cable, providing ample length for discreet routing of the cable throughout most vehicle interiors.

First, check the LED indicator light on the hardwire kit; if it's off, there's no power reaching the kit. Verify the fuse tap is correctly seated in the fuse box and that the original fuse (in the lower slot) is functional. Also, ensure the ground wire is securely attached to a clean, unpainted metal surface on the car's chassis.

This usually means the hardwire kit is connected to an 'always-on' fuse. If you want the dash cam to turn off with the ignition, you need to relocate the fuse tap to a 'switched' fuse that only receives power when the ignition is on (e.g., radio, cigarette lighter, or accessory circuit).

While less common for hardwire kits, ensure the power supply is stable. Double-check all connections. If the issue persists, test the dash cam with its original 12V car charger to rule out a dash cam fault or an issue specific to the hardwire connection (e.g., inadequate grounding).