National Skirting Lambs Tongue II - White

Use a sharp, fine-toothed saw, such as a mitre saw or a hand saw with fine teeth, for clean cuts. Support the board securely to prevent chipping, especially on the decorative profile.

While made from moisture-resistant MDF, it is best suited for areas with moderate humidity. For bathrooms, ensure it is thoroughly painted and sealed, and consider additional moisture protection if the area experiences high levels of steam or direct water contact.

Typically, two coats of your chosen paint are recommended for full coverage and a smooth finish over the white primer. Allow adequate drying time between coats.

A strong, flexible adhesive designed for wood or MDF skirting boards is recommended. Follow the adhesive manufacturer's instructions for application and drying times.

A light sanding with fine-grit sandpaper (e.g., 180-220 grit) can help create a smoother surface for paint adhesion, especially if the primer feels very smooth or has any minor imperfections.

The skirting board is 250mm in height, 3040mm in length, and 18mm in thickness.

Ensure the wall surface is clean, dry, and free from dust or grease. Use a high-quality adhesive specifically designed for skirting boards, and apply sufficient pressure during fixing. If using nails or screws, ensure they are driven in securely.

Ensure the surface was clean and dry before painting. Lightly sand the primed surface if it feels too smooth. Apply primer and paint in thin, even coats, allowing each coat to dry completely before applying the next. Use paint suitable for primed MDF.

Use a sharp, fine-toothed saw blade designed for cutting MDF. Ensure the board is securely supported during cutting to prevent vibration. A zero-dust extraction system can also help minimize chipping.

Ensure precise mitre cuts for corners. For minor gaps, use a suitable wood filler or decorators caulk after painting but before final finishing. Fill and sand smooth before applying a final coat of paint.